2010 Chevrolet Suburban 2500 Owner's Manual - Page 533

7. Remove any rust or dirt from the wheel bolts, mounting surfaces, and spare wheel. 8. Put the wheel nuts back on with the rounded end of the nuts toward the wheel after mounting the spare tire. { WARNING: Never use oil or grease on bolts or nuts because the nuts might come loose. The vehicle's wheel could fall off, causing a crash. 9. Tighten each wheel nut by hand. Then use the wheel wrench to tighten the nuts until the wheel is held against the hub. 10. Turn the wheel wrench counterclockwise to lower the vehicle. Lower the jack completely. 11. Tighten the nuts firmly in a crisscross sequence as shown by turning the wheel wrench clockwise. { WARNING: Rust or dirt on a wheel, or on the parts to which it is fastened, can make wheel nuts become loose after time. The wheel could come off and cause an accident. When changing a wheel, remove any rust or dirt from places where the wheel attaches to the vehicle. In an emergency, use a cloth or a paper towel to do this; but be sure to use a scraper or wire brush later, if needed, to get all the rust or dirt off. See Changing a Flat Tire on page 6‑88. 6-99