2010 Chevrolet Suburban 2500 Owner's Manual - Page 479

Replacing Brake System Parts The braking system on a vehicle is complex. Its many parts have to be of top quality and work well together if the vehicle is to have really good braking. The vehicle was designed and tested with top-quality brake parts. When parts of the braking system are replaced - for example, when the brake linings wear down and new ones are installed - be sure to get new approved replacement parts. If this is not done, the brakes might not work properly. For example, if someone puts in brake linings that are wrong for the vehicle, the balance between the front and rear brakes can change - for the worse. The braking performance expected can change in many other ways if the wrong replacement brake parts are installed. { DANGER: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. Vehicle Storage { WARNING: Batteries have acid that can burn you and gas that can explode. You can be badly hurt if you are not careful. See Jump Starting on page 6‑46 for tips on working around a battery without getting hurt. Infrequent Usage: Remove the black, negative (−) cable from the battery to keep the battery from running down. Extended Storage: Remove the black, negative (−) cable from the battery or use a battery trickle charger. Battery If the vehicle is a Two‐mode Hybrid, see the Two‐mode Hybrid manual for more information. Refer to the replacement number on the original battery label when a new battery is needed. See Engine Compartment Overview on page 6‑16 for battery location. 6-45