2010 Chevrolet Suburban 2500 Owner's Manual - Page 218

Cargo Cover To remove the cover from a regular wheelbase model: 1. Let the cover go all the way into the holder. 2. Then, grasping the driver's side cover end cap, push the cover end cap toward the passenger side of the vehicle. 3. Swing the cover rearward and take it out of the vehicle. To put the cover in the vehicle: 1. Make sure the cover slot in the holder faces rearward with the round surface facing down. 2. Then, hold the cover at an angle and place the cover end cap into the slot in the passenger side trim panel. 3. Move the other end of the cover forward and hold it next to the driver's side trim panel slot. 4. Press the end caps in, to allow the cover to fit into the trim slot. 5. Pull lightly on the cover holder to make sure it is secure. On extended wheelbase models there are two cover positions. The slots furthest forward allow the cover to be used if the third seat is removed or folded down. The cover can be installed and removed from either side. { WARNING: An improperly stored cargo cover could be thrown about the vehicle during a collision or sudden maneuver. Someone could be injured. If the cover is removed, always store it in the proper storage location. When it is replaced, always be sure that it is securely reattached. To use the cargo cover, if equipped: 1. Pull the cover handle toward the rear of the vehicle. 2. Latch the cover posts into the retaining sockets on the cargo area trim panels. To return the cover to the retracted position: 1. Pull up on the cover handle to release the cover posts from the retaining sockets. 2. Let the cover move forward to the full retracted position. 3-78