2010 Chevrolet Suburban 2500 Owner's Manual - Page 162

Programming the Power Windows If the battery on the vehicle has been recharged, disconnected, or is not working, you will need to reprogram each front power window for the express-up feature to work. Before reprogramming, replace or recharge the vehicle's battery. To program each front window, follow these steps: 1. With the ignition in ACC/ACCESSORY, ON/RUN, or when Retained Accessory Power (RAP) is active, close all doors. 2. Press and hold the power window switch until the window is fully open. 3. Pull the power window switch up until the window is fully closed. 4. Continue holding the switch up for approximately two seconds after the window is completely closed. The window is now reprogrammed. Repeat the process for the other windows. Window Lockout o (Window Lockout): The rear window lockout button is located on the driver door near the window switches. Press the right side of the button to disable the rear window controls. The light on the button will illuminate, indicating the feature is in use. The rear windows still can be raised or lowered using the driver window switches when the lockout feature is active. To restore power to the rear windows, press the button again. The light on the button will go out. Sun Visors Swing down the visor to block out glare. It can also be detached from the center mount and moved to the side to block glare from that direction. The driver visor may also have buttons for a built-in garage door opener. See Universal Home Remote System on page 3‑68 for more information. Lighted Visor Vanity Mirror Pull the visor down and lift the cover to access the mirror. A light comes on when the cover is lifted and goes out when it is closed. 3-22