2010 Chevrolet Suburban 2500 Owner's Manual - Page 567
2010 Chevrolet Suburban 2500 Manual
Page 567 highlights
care should be taken to not directly spray the transfer case output seals. High pressure water can overcome the seals and contaminate the transfer case fluid. Contaminated fluid will decrease the life of the transfer case and should be replaced. . . Evaporative control system inspection. Check all fuel and vapor lines and hoses for proper hook‐up, routing, and condition. Check that the purge valve, if the vehicle has one, works properly. Replace as needed. An Emission Control Service. The U.S. Environmental Protection Agency or the California Air Resources Board has determined that the failure to perform this maintenance item will not nullify the emission warranty or limit recall liability prior to the completion of the vehicle's useful life. We, however, urge that all recommended maintenance services be performed at the indicated intervals and the maintenance be recorded. Four‐wheel drive only: Transfer case fluid change (normal service). Check vent hose at transfer case for kinks and proper installation. Check to be sure vent hose is unobstructed, clear, and free of debris. During any maintenance, if a power washer is used to clean mud and dirt from the underbody, care should be taken to not directly spray the transfer case output seals. High pressure water can overcome the seals and contaminate the transfer case fluid. Contaminated fluid will decrease the life of the transfer case and should be replaced. Spark plug replacement and spark plug wires inspection. An Emission Control Service. . First Engine Oil Change After Every 240 000 km/150,000 Miles . First Engine Oil Change After Every 160 000 km/100,000 Miles . Engine cooling system drain, flush, and refill, cooling system and cap pressure check, and cleaning of outside of radiator and air conditioning condenser (or every 5 years, whichever occurs first). See Engine Coolant on page 6‑31. An Emission Control Service. Engine accessory drive belt inspection for fraying, excessive cracks, or obvious damage and replacement, if needed. An Emission Control Service. Automatic transmission fluid change (normal service). See Automatic Transmission Fluid (4-Speed Transmission) on page 6‑23 or Automatic Transmission Fluid (6-Speed Transmission) on page 6‑26. . 7-7