2014 Dodge Durango Owner Manual - Page 248

246 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to proTo reprogram a channel that has been previously trained, gram while keeping the HomeLink® indicator light in follow these steps: view. 1. Cycle the ignition to the ON/RUN position. 3. Simultaneously press and hold both the HomeLink® 2. Press and hold the desired HomeLink® button until button you want to program and the hand-held transthe indicator light begins to flash after 20 seconds. Do mitter button. not release the button. 4. Continue to hold both buttons and observe the indi3. Without releasing the button proceed with "Programcator light. HomeLink® indicator will flash slowly ming A Rolling Code" step 2 and follow all remaining and then rapidly after HomeLink® has received the steps. frequency signal from the hand-held transmitter. Release both buttons after the indicator light changes Programming A Non-Rolling Code from slow to rapid. For programming Garage Door Openers manufactured 5. Press and hold the programmed HomeLink® button before 1995. and observe the indicator light. 1. Cycle the ignition to the ON/RUN position. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pressed. Reprogramming A Single HomeLink® Button