2014 Dodge Durango Owner Manual - Page 484

482 STARTING AND OPERATING If the ignition switch is cycled, this sequence will repeat, providing the system fault still exists. If the system fault no longer exists, the Tire Pressure Monitoring Telltale Light will no longer flash, the ЉSERVICE TPM SYSTEMЉ message will not be present, and a pressure value will be displayed instead of dashes. A system fault can occur by any of the following: 1. 2. 3. 4. 5. The EVIC will also display a ЉSERVICE TPM SYSTEMЉ message for a minimum of five seconds when a system fault is detected possibly related to an incorrect sensor location fault. In this case, the ЉSERVICE TPM SYSTEMЉ message is then followed by a graphic display, with pressure values still shown. This indicates the pressure values are still being received from the TPM Sensors but they may not be located in the correct vehicle position. Jamming due to electronic devices or driving next to However, the system still needs to be serviced as long as facilities emitting the same Radio Frequencies as the the ЉSERVICE TPM SYSTEMЉ message exists. TPM sensors. NOTE: There is no tire pressure monitoring sensor in the Installing some form of aftermarket window tinting spare tire. The TPMS will not be able to monitor the tire that affects radio wave signals. pressure. If you install the spare tire in place of a road tire Lots of snow or ice around the wheels or wheel that has a pressure below the low-pressure warning limit, housings. upon the next ignition switch cycle, the Tire Pressure Monitoring Telltale Light will remain ON, a chime will Using tire chains on the vehicle. sound, and the EVIC will still display a pressure value in Using wheels/tires not equipped with TPM sensors. the different color graphic display and an ЉInflate to XXX kPaЉ message will be displayed. After driving the vehicle