2014 Dodge Durango Owner Manual - Page 250

248 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Continue to press and hold the HomeLink® button, while you press and release ("cycle"), your hand-held transmitter every two seconds until HomeLink® has If you unplugged the garage door opener/device for successfully accepted the frequency signal. The indi- programming, plug it back in at this time. cator light will flash slowly and then rapidly when Reprogramming A Single HomeLink® Button fully trained. To reprogram a channel that has been previously trained, 4. Watch for the HomeLink® indicator to change flash follow these steps: rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage 1. Cycle the ignition to the ON/RUN position. door may open and close while you are programming. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do 5. Press and hold the programmed HomeLink® button not release the button. and observe the indicator light. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pressed. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels.