2014 Dodge Durango Owner Manual - Page 33

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31 To Exit Remote Start Mode Without Driving The Vehicle Push and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: • For vehicles not equipped with the Keyless Enter-NGo™ feature, the ignition switch must be in the ON/RUN position in order to drive the vehicle. 2 NOTE: To avoid unintentional shutdowns, the system • For vehicles not equipped with the Keyless Enter-Nwill disable the one time push of the REMOTE START Go™ feature, the message "Remote Start Active - button for two seconds after receiving a valid Remote Insert Key and Turn to Run" will display in the EVIC Start request. until you insert the key. Refer to "Electronic Vehicle Information Center (EVIC)" for further information. To Exit Remote Start Mode And Drive The Vehicle Before the end of 15 minute cycle, push and release the • For vehicles equipped with the Keyless Enter-N-Go™ feature, the message "Remote Start Active - Push UNLOCK button on the RKE transmitter to unlock the Start Button" will display in the EVIC until you push doors and disarm the Vehicle Security Alarm (if the START button. equipped). Then, prior to the end of the 15 minute cycle, push and release the START/STOP button. If the START/ Remote Start Comfort Systems - If Equipped STOP button is not present, insert the Key Fob into the When remote start is activated, the heated steering ignition switch and turn the switch to the ON/RUN wheel, and driver heated seat features will automatically position. turn on in cold weather. In warm weather, the driver