2014 Dodge Durango Owner Manual - Page 249

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 247 • To program the remaining two HomeLink® buttons, Canadian/Gate Operator Programming repeat each step for each remaining button. DO NOT For programming transmitters in Canada/United States erase the channels. that require the transmitter signals to "time-out" after several seconds of transmission. Reprogramming A Single HomeLink® Button To reprogram a channel that has been previously trained, Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transfollow these steps: mission - which may not be long enough for HomeLink® 1. Cycle the ignition to the ON/RUN position. to pick up the signal during programming. Similar to this 2. Press and hold the desired HomeLink® button until Canadian law, some U.S. gate operators are designed to the indicator light begins to flash after 20 seconds. Do time-out in the same manner. not release the button. It may be helpful to unplug the device during the cycling 3. Without releasing the button proceed with "Program- process to prevent possible overheating of the garage ming A Non-Rolling Code" step 2 and follow all door or gate motor. remaining steps. 1. Cycle the ignition to the ON/RUN position. 3