2015 Dodge Durango User Guide - Page 15

GETTING STARTED • After pushing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before you can lock or unlock the vehicle using the door handle. This is done to allow you to check if the vehicle is locked by pulling the door handle, without the vehicle reacting and unlocking. • If a Keyless Enter-N-Go™ door handle has not been used for 72 hours, the Keyless Enter-N-Go™ feature for that handle may time out. Pulling the deactivated front door handle will reactivate the door handle's Keyless Enter-N-Go™ feature. Lock Or Unlock The Liftgate • To Lock The Liftgate - With a Remote Keyless Entry (RKE) transmitter within 3 ft (1.0 m) of the liftgate, push the passive entry lock button located to the right of electronic liftgate handle. • To Unlock/Enter The Liftgate - The liftgate passive entry unlock feature is built into the electronic liftgate handle. With a Remote Keyless Entry (RKE) transmitter within 3 ft (1.0 m) of the liftgate, push the electronic release switch to open the liftgate. NOTE: Refer to your Owner's Manual on the DVD for further information. Electronic Liftgate Handle 1 - Electronic Release Switch 2 - Lock Button Location Engine Starting/Stopping Starting Perform the following starting procedure with a Remote Keyless Entry (RKE) transmitter inside the vehicle: 1. While pushing the brake pedal, push the ENGINE START/STOP button once. If the engine fails to start, the starter will disengage automatically after 10 seconds. 2. To stop the cranking of the engine prior to the engine starting, push the button again. Engine START/STOP Button 13