1997 Ford Explorer Owner Guide 1st Printing - Page 210
1997 Ford Explorer Manual
Page 210 highlights
Maintenance and care Replacing the headlamps 1. With the flat side of the bulb's base facing upward, insert the glass end of the bulb into the socket. Turn the bulb left or right to line up the grooves in the plastic base with the tabs in the socket. Push the bulb into the socket until the plastic base contacts the rear of the socket. 2. Slip the retaining ring over the plastic base until it hits the rear of the socket. Lock the ring by rotating it clockwise until you feel it stop. 3. Press the electrical connector into the rear of the plastic base until it snaps, locking it into position. 4. Turn the headlamps on and ensure they work properly. LIFT Foglamps (if equipped) 1. Disconnect the electrical connector from the back of the foglamp by turning it counterclockwise. 2. Remove the bulb by lifting the retaining clip and pulling the bulb from the assembly. 3. Replace the bulb and insert the bulb assembly back into the foglamp. 211