1997 Ford Explorer Owner Guide 1st Printing - Page 22

Instrumentation 2. With the brake lamps, parking lamps and headlamps off, turn the ignition switch to ON or ACC. 3. After M/C briefly illuminates (about two seconds), press the brake pedal. If "CHECK EXTERIOR LAMPS" is displayed, then a brake lamp is burned out. If this message is not displayed, proceed to the next step. 4. Turn the light switch to the parking lamp positions. If "CHECK EXTERIOR LAMPS" is displayed, then a rear side marker is burned out. If this message is not displayed, proceed to the next step. OFF DIM 4 H C 2 1 F E 0 3 5 6 40 30 40 50 60 70 o o o o 100 80 60 120 80 140 UNLEADED FUEL ONLY 90 180 0 0 0 0 0 0 160 20 100 110 120 20 RPM x 1000 10 0 km/h P R N D 2 1 OFF ON RSM SET ACC OFF COAST SRS 5. Turn the light switch to the headlamp position. If "CHECK EXTERIOR LAMPS" is displayed, then a low beam headlamp is burned out. If you use additional lights, such as trailer lights, or replace bulbs with equipment that is not equal to the original Ford equipment, you may 23