2002 Ford Windstar Owner Guide 2nd Printing - Page 94

Driver Controls POSITIVE RETENTION FLOOR MAT (IF EQUIPPED) To install floor mats that have a retention post: Position the floor mat so that the eyelet is over the pointed end of the retention post and rotate forward to lock in. Make sure that the mat does not interfere with the operation of the accelerator or the brake pedal. To remove the floor mat, reverse the installation procedure. To install floor mats that have a screw in retainer: 1. Move the driver's seat to the most rearward position 2. Position the driver's side floor mat with the rear of the mat against left (outboard) front edge of seat track mounting bracket. 3. Use a screwdriver to screw locator post into vehicle carpeting. Exert pressure while turning to pierce the carpeting. When installed properly, the locator will not screw down tightly, but will rotate freely. Use only Ford original Equipment floor mats. Do not stack multiple floor mats over the Ford original equipment floor mats as they are not positively retained. HOMELINKா UNIVERSAL TRANSCEIVER (IF EQUIPPED) The HomeLink௡ Universal Transceiver, located on the driver's visor, provides a convenient way to replace up to three hand-held transmitters with a single built-in device. This feature will learn the radio frequency codes of most current transmitters to operate garage doors, entry gate operators, security systems, entry door locks, and home or office lighting. When programming your HomeLink௡ Universal Transceiver to a garage door or gate, be sure that people and objects are out of the way to prevent potential harm or damage. Do not use the HomeLink௡ Universal Transceiver with any garage door opener that lacks safety stop and reverse features as required by U.S. 94