2002 Ford Windstar Owner Guide 2nd Printing - Page 97
2002 Ford Windstar Manual
Page 97 highlights
Driver Controls Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink button (note step 3 in the "Programming" section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink. The red indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. • Proceed with step 4 in the "Programming" section. Operating the HomeLinkா Universal Transceiver To operate, simply press and release the appropriate HomeLink button. Activation will now occur for the trained product (garage door, gate operator, security system, entry door lock, or home or office lighting etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties, contact Homelink at www.homelink.com.or 1-800-355-3515. Rolling code programming To train a garage door opener (or other rolling code equipped devices) with the rolling code feature, follow these instructions after completing the "Programming" in this section. (A second person may make the following training procedures quicker & easier) 1. Locate the "learn" or "smart" button on the garage door motor head unit. Exact location and color of the button may vary by product brand. If there is difficulty locating the "learn" or "smart" button refer to the device's owner manual or contact Homelink at 1-800-355-3515 or on the Internet at www.homelink.com. 2. Press and release the "learn" or "smart" button on the garage door motor head unit. Note: Following step 2, there are 30 seconds in which to initiate step 3. 97