2011 Ford F150 Regular Cab Owner Guide 3rd Printing - Page 118

Driver Controls • Fixed code garage door openers were produced prior to 1996. Fixed code uses the same coded signal every time. It is manually programmed by setting DIP switches for a unique personal code. If you do not know if your garage door opener is a rolling code or 1 2 3 4 5 6 7 8 9 10 11 12 fixed code device, open your garage CTS 206-12 T124 door opener's remote control battery cover. If a panel of DIP switches is present your garage door opener is a fixed code device. If not, your garage door opener is a rolling code device. O N Note: Programming the Car2U௡ system to a community gate will require a unique set of instructions depending on the gate system model. Contact the Car2U௡ help line at 1-866-572-2728 to program your Car2U௡ system. Note: Accidentally entering the program mode may override previously programmed buttons. This can happen by pressing and releasing the outer two buttons, or all three buttons, simultaneously. If this happens, do not press any button until the module times out after approximately 2.5 seconds and resets to normal mode. When time-out occurs, all three LEDs will flash rapidly for a few seconds then turn off. Any settings should remain as previously set. Rolling code programming Note: Programming the rolling code garage door opener involves time-sensitive actions. Read the entire procedure prior to beginning so you will know which actions are time-sensitive. If you do not follow the time-sensitive actions, the device will time out and you will have to repeat the procedure. Note: Do not program the Car2U௡ system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 118 2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)