2011 Ford F150 Regular Cab Owner Guide 3rd Printing - Page 86

Lights 3. Turn on the low beam headlamps to illuminate the wall or screen and open the hood. Cover one of the headlamps so no light hits the wall. 4. On the wall or screen you will observe a light pattern with a distinct horizontal edge towards the right. If this edge is not at the horizontal reference line, the beam will need to be adjusted so the edge is at the same height as the horizontal reference line. 5. Locate the vertical adjuster on each headlamp, then use a #2 Philips screwdriver to turn the adjuster either counterclockwise (to adjust up) or clockwise (to adjust down) aligning the upper edge of the light pattern up to the horizontal line. 6. HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS NON-ADJUSTABLE. 7. Repeat Steps 3-5 for the other headlamp. 8. Close the hood and turn off the lamps. TURN SIGNAL CONTROL The turn signal lever does not mechanically lock in the upward or downward position when activated. The turn signal control activation and cancellation is electronic. • To operate the left turn signal, push the lever down until it stops and release. • To operate the right turn signal, push the lever up until it stops and release. • To manually cancel turn signal operation, push the lever again in either direction. Lane change To indicate a left or right lane change: • Push the lever up/down to the first stop position and release. The turn signals will flash three times and stop. 86 2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)