2014 Ford F250 Super Duty Super Cab Diesel Supplement Printing 1 - Page 67
2014 Ford F250 Super Duty Super Cab Manual
Page 67 highlights
Scheduled Maintenance SPECIAL OPERATING CONDITIONS SCHEDULED MAINTENANCE If you operate your vehicle primarily in any of the following conditions, you need to perform extra maintenance as indicated. If you operate your vehicle occasionally under any of these conditions, it is not necessary to perform the extra maintenance. For specific recommendations, see your dealership service advisor or technician. Towing a trailer or using a car-top carrier As required Change the engine oil and filter as indicated by the information display, and perform the services listed in the scheduled maintenance chart. See the axle maintenance items under Exceptions. Every 15000 miles (24000 km) or 600 engine hours Inspect the coolant concentration (freeze-point protection) and additive (corrosion inhibitor) strength. Add engine coolant additive if necessary. Every 15000 miles (24000 Replace the engine-mounted and frame-mounted fuel km), 6 months, 600 engine filters. hours, or as indicated by the information display Every 30000 miles (48000 Replace the wheel bearing grease and grease seals if using km) non-sealed bearings. (Two-wheel drive vehicles) Every 60000 miles (96000 Change the transfer case fluid. (Four-wheel drive vehicles) km) Every 60000 miles (96000 Flush and refill the engine coolant. Do not add engine km) or 2400 engine hours coolant additive. Note: When adding coolant additive, do not exceed the specified maximum of 48 fluid ounces (1.4 liters). Operating the engine with excessive coolant additive may cause overheating which could lead to severe, permanent engine damage. Note: After the initial coolant flush and fill at 60000 miles (96000 kilometers) or 2400 engine hours, flush and fill every 45000 miles (72000 kilometers) or 1800 engine hours thereafter. 64 Super Duty (TFA)