2009 Infiniti FX50 Owner's Manual - Page 105

2 front * (High) or toward the rear (Low). 3 * 1 * Intermittent (INT) - intermittent operation (not adjustable) 2 * Low (ON) - continuous low speed operation 3 Push the switch forward * to operate the washer. Then the wiper will also operate several times. . . High - High sensitive operation Low - Low sensitive operation To turn the rain-sensing auto wiper system off, push up the lever to the OFF position, or pull down the lever to the LO or HI position. CAUTION Do not touch the rain sensor and around it when the wiper switch is in the INT position and the ignition switch is in the ON position. The wipers may operate unexpectedly and cause to an injury or a wiper damage. . The rain-sensing auto wipers are intended for use during rain. If the switch is left in the INT position, the wipers may operate unexpectedly when dirt, fingerprints, oil film or insects are stuck on or around the sensor. The wipers may also operate when exhaust gas or moisture affect the rain sensor. The rain-sensing auto wipers may not operate if rain does not hit the rain sensor even if it is raining. SIC3627 REAR WINDOW WIPER AND WASHER OPERATION If the rear window wiper operation is interrupted by snow etc., the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to OFF and remove the snow etc. on and around the wiper arms. After about 1 minute, turn the switch ON again to operate the wiper. The rear window wiper and washer operate when the ignition switch is in the ON position. Turn the switch clockwise from the OFF position to operate the wiper. Instruments and controls . 2-35