2009 Infiniti FX50 Owner's Manual - Page 47

9. Check that the retractor is in the mode by trying to pull more seat out of the retractor. If you cannot any more belt webbing out of retractor, the retractor is in the mode. ALR belt pull the ALR 10. Check to make sure the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 3 through 8. Front facing - step 8 8. Before placing the child in the child restraint, hold the child restraint near the seat belt path and use force to push the child restraint from side to side, and tug it forward to make sure that it is securely held in place. It should not move more than 1 in (25 mm). If it does move more than 1 in (25 mm), pull again on the shoulder belt to further tighten the child restraint. If you are unable to properly secure the restraint, move the restraint to another seating position and try again, or try a different child restraint. Not all child restraints fit in all types of vehicles. SSS0641 Front facing - step 11 11. If the child restraint is installed in the front passenger seat, push the ignition switch to the ON position. The front passenger air bag status light should illuminate. If this light is not illuminated, see "Front passenger air bag and status light" later in this section. Move the child restraint to another seating position. Have the system checked by an INFINITI dealer. After the child restraint is removed and the seat belt is fully retracted, the ALR mode (child restraint mode) is canceled. SSS0676 1-30 Safety - Seats, seat belts and supplemental restraint system