2009 Infiniti FX50 Owner's Manual - Page 98
2009 Infiniti FX50 Manual
Page 98 highlights
Current fuel consumption ? Average fuel consumption and speed ? Elapsed time and trip odometer ? Distance to empty (dte) ? Outside air temperature (ICY) ? Setting ? Warning check at the same time.) The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows 1. Current fuel consumption The current fuel consumption mode shows the current fuel consumption. 3. Elapsed time and trip odometer (mls or km) Elapsed time: The elapsed time mode shows the time since the last reset. The displayed time can B be reset by pushing the switch * for longer than 1 second. (The trip odometer is also reset at the same time.) Trip odometer: The trip odometer mode shows the total distance the vehicle has been driven since the last reset. Resetting is done by pushing B the switch * for longer than 1 second. (The elapsed time is also reset at the same time.) 2. Average fuel consumption (MPG or l (liter)/100 km) and speed (MPH or km/h) SIC3829 Fuel consumption: The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pushing the B switch * for longer than 1 second. (The average speed is also reset at the same time.) The display is updated every 30 seconds. At about the first 1/3 mile (500 m) after a reset, the display shows Speed: The average speed mode shows the average vehicle speed since the last reset. Resetting is done by pushing the B switch * for longer than 1 second. (The average fuel consumption is also reset TRIP COMPUTER Switches for the trip computer are located on the right side of the combination meter panel. To operate the trip computer, push the switches as shown above. A * B * switch switch When the ignition switch is pushed to the ON position, modes of the trip computer switch can be selected by pushing the A *. A Each time the switch * is pushed, the display will change as follows: 4. Distance to empty (dte - mls or km) The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. 2-28 Instruments and controls