2009 Infiniti FX50 Owner's Manual - Page 254
2009 Infiniti FX50 Manual
Page 254 highlights
phone under the following conditions: - Your vehicle is outside of the telephone service area. - Your vehicle is in an area where it is difficult to receive radio waves; such as in a tunnel, in an underground parking garage, behind a tall building or in a mountainous area. - Your cellular phone is locked in order not to be dialed. . When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. Immediately after the ignition switch is pushed to the ON position, it may be impossible to receive a call for a short period of time. Do not place the cellular phone in an area surrounded by metal or far away from the in-vehicle phone module to prevent tone quality degradation and wireless connection disruption. While a cellular phone is connected through the Bluetooth® wireless connection, the battery power of the cellular phone may discharge quicker than usual. . If the Bluetooth® Hands-Free Phone System seems to be malfunctioning, please visit www.infiniti.com/bluetooth for troubleshooting help. Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. Refer to the cellular phone Owner's Manual regarding the telephone pairing procedure specific to your phone, battery charging, cellular phone antenna, etc. The antenna display on the monitor will not coincide with the antenna display of some cellular phones. Keep the interior of the vehicle as quiet as possible to hear the caller's voice clearly as well as to minimize its echoes. If reception between callers is unclear, adjusting the incoming or outgoing call volume may improve the clarity. REGULATORY INFORMATION FCC Regulatory information - CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. - Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device . . . . . IC Regulatory information - Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. - This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. . . . 4-86 Monitor, climate, audio, phone and voice recognition systems