2009 Infiniti FX50 Owner's Manual - Page 332

SELECTING THE VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE To choose the vehicle-to-vehicle distance 1 control mode * , quickly push and release A the MAIN switch * . The detection range of the sensor is approximately 390 ft (120 m) ahead. WARNING . This system is only an aid to assist the driver and is not a collision warning or avoidance device. It is the driver's responsibility to stay alert, drive safely and be in control of the vehicle at all times. The system is primarily intended for use on straight, dry, open roads with light traffic. It is not advisable to use the system in city traffic or congested areas. This system will not adapt automatically to road conditions. This system should be used in evenly flowing traffic. Do not use the system on roads with sharp curves, or on icy roads, in heavy rain or in fog. VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE In the vehicle-to-vehicle distance control mode, the Intelligent Cruise Control (ICC) system automatically maintains a selected distance from the vehicle traveling in front of you according to that vehicle's speed (up to the set speed), or at the set speed when the road ahead is clear. With ICC, the driver can maintain the same speed as other vehicles without the constant need to adjust the set speed as you would with a normal cruise control system. . SSD0738 PRECAUTIONS ON VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE The system is intended to enhance the operation of the vehicle when following a vehicle traveling in the same lane and direction. A If the distance sensor * detects a slower moving vehicle ahead, the system will reduce the vehicle speed so that your vehicle follows the vehicle in front at the selected distance. . The distance sensor will not detect the following objects: ...Stationary and slow moving vehicles Pedestrians or objects in the roadway Oncoming vehicles in the same lane Motorcycles traveling offset in the Starting and driving The system automatically controls the throttle and applies the brakes (up to 25% of vehicle braking power) if necessary. 5-29