2004 Mazda MAZDA6 Owner's Manual - Page 144

J56J_8S11-EA-03G_Edition1.book Page 48 Tuesday, June 24, 2003 6:29 PM Driving Your Mazda Switches and Controls 4. After the HomeLink indicator light changes from a slow to a rapidly blinking light, release both the HomeLink and hand-held transmitter buttons. NOTE 7. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) NOTE There are 30 seconds in which to initiate step 8. 8. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the "press/hold/release" sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming process. HomeLink should now activate your rolling code equipped device. NOTE If the HomeLink indicator light does not change to a rapidly blinking light, contact HomeLink at www.homelink.com or call 1-800-3553515 for assistance. 5. Press and hold the just-trained HomeLink button and observe the indicator light. If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE To program the remaining two HomeLink buttons, begin with "Programming" - step 2. Do not repeat step 1. If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with "Programming" steps 6-8 to complete the programming of a rolling code equipped device (most commonly a garage door opener). 6. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the hanging antenna wire is attached to the motorhead unit. To program the remaining two HomeLink buttons, begin with "Programming" - step 2. Do not repeat step 1. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. 5-48 Form No. 8S11-EA-03G