2004 Mazda MAZDA6 Owner's Manual - Page 238
2004 Mazda MAZDA6 Manual
Page 238 highlights
J56J_8S11-EA-03G_Edition1.book Page 18 Tuesday, June 24, 2003 6:29 PM Maintenance and Care Owner Maintenance If new fluid is required frequently, consult an Authorized Mazda Dealer. 3.0-liter engine Inspect the fluid level at each engine oil change. Add fluid if necessary; it does not require periodic changing. Automatic transaxle Fluid (ATF) M Inspecting Automatic transaxle Fluid Level The automatic transaxle fluid level should be inspected regularly. Measure it as described below. The volume of fluid changes with the temperature. Fluid must be checked at idle without driving at normal operating temperature. Loosen High OK Low Tighten CAUTION • Low fluid level causes transaxle slippage. Overfilling can cause foaming, loss of fluid, and transaxle malfunction. • Use specified fluid (page 10-3). A nonspecified fluid could result in transaxle malfunction and failure. 1. Park on a level surface and set the parking brake firmly. 2. Idle the engine about two minutes. Push down on the brake pedal. 3. Move the shift lever through all ranges and set it at P. The level must be kept between the H and L marks. Visually examine the lines and hoses for leaks and damage. 1. Park on a level surface, well off the right-of-way, and set the parking brake firmly. 2. Turn off the engine and allow it to cool. 3. Remove the filler cap and attached dipstick. 4. Wipe them clean and put them back. 5. Remove again and inspect the level. 6. It must be between H and L. Add fluid if necessary. Don't overfill. If new fluid is required frequently, consult an Authorized Mazda Dealer. 8-18 Form No. 8S11-EA-03G