1998 Mercury Villager Owner Guide 1st Printing - Page 120

ID Code Programming Procedure NOTE: All transmitters must be programmed (or reprogrammed) at the same time. If the programming mode is entered and the transmitters are not programmed (or reprogrammed) at the same time, they will not operate with the system. 1. Enter vehicle and close and lock all doors. 2. Insert and remove key from ignition six times within ten (10) seconds. The instrument panel lights will flash twice. 3. Turn ignition key to the ACC position. 4. Press the LOCK button on the remote transmitter once. 5. To enter additional remote controllers (including the original), unlock, then lock the driver door using the power door lock switch. 6. Press the LOCK button on a new remote transmitter. The instrument panel lights will flash twice, indicating code is entered. 7. Repeat steps 5 and 6 as needed (up to four remote transmitters may be programmed). Anti-Theft System (If equipped) This system helps protect your vehicle against break-ins or theft by monitoring all doors, the hood and the liftgate lock cylinder. When an unauthorized entry occurs, the system triggers and will: Ⅵ flash the headlamps and hazard lamps Ⅵ honk the horn Ⅵ disable the starting circuit to prevent the vehicle from being started 116