1998 Mercury Villager Owner Guide 1st Printing - Page 75

Controls and Features Changing the Display Mode (English/Metric) To switch between the English and Metric display mode, press the DEFROST and A/C buttons simultaneously while rotating the fan speed dial upward until it stops moving. After one second, the display will begin to toggle between English and Metric. Fan Speed and Thumbwheel The ATC automatically adjusts the fan speed to the existing conditions. To control the fan speed yourself, use the thumbwheel located at the extreme right side of the ATC control panel. Using the thumbwheel cancels the automatic fan speed control, and causes a to appear in the display window. Rotate the thumbwheel up for HI speeds and down for LO speeds. To return to automatic fan control, press the AUTOMATIC button. Airflow Function Selector Buttons Your ATC has five buttons which allow you to make special selections for airflow. The buttons are grouped in the middle of the ATC panel and allow you to determine airflow location. Pressing any of the function selector buttons illuminates the button pushed and directs airflow to the appropriate location. The temperature of the airflow will still be automatically controlled. Return to fully automatic operation by pushing the AUTOMATIC button. Push this button for airflow to the floor and windshield at the same time. The indicator light illuminates, and the display window shows the set temperature. However, the air is not cooled below the temperature outside of the vehicle regardless of the temperature setting unless the A/C button is pushed. 71