1998 Mercury Villager Owner Guide 1st Printing - Page 276

Jump-Starting 1. Make sure that the jumper cables are not in the way of moving engine parts, then start the booster vehicle. Run the engine at a moderate speed. 2. Let the discharged battery charge for a few minutes and then start the disabled vehicle. It may take a couple of tries before the vehicle starts. If the vehicle does not start after several attempts, there may be a different problem. 3. When both vehicles are running, let them idle for a few minutes to charge the discharged battery. Removing jumper cables 1. Always remove the jumper cables in the reverse order. Remove the negative (-) end of the jumper cable from the metallic surface on the engine or frame of the disabled vehicle. 2. Remove the negative (-) cable from the booster battery. 3. Remove the positive (+) cable from the booster battery. 4. Remove the other end of the positive (+) cable from the discharged battery. If you need to replace your battery, see Battery in the Maintenance and Care chapter. Towing Your Vehicle If you need to have your vehicle towed, contact a professional towing service or, if you are a member, your roadside assistance center. DO NOT TOW YOUR VILLAGER WITH SLINGBELT EQUIPMENT. Ford Motor Company has not developed or approved a T-hook sling-type procedure. Use wheel lift or flatbed equipment. 272