1998 Mercury Villager Owner Guide 1st Printing - Page 74
1998 Mercury Villager Manual
Page 74 highlights
When in AUTOMATIC and weather conditions require heat, air is sent to the floor. However, a feature is included in the ATC to prevent blowing cold air to the floor if the engine coolant is not warm enough to provide heating. Within three or four minutes (once the engine coolant is warm enough), the fan speed gradually increases and airflow changes to the floor. If specific conditions exist (such as window fogging), the five override buttons allow specific airflow selection. The dial allows you to adjust the fan speed to suit your needs. Temperature Selection The TEMP button on the left side of the control panel is for temperature selection. The side lowers the set temperature, and the side raises the set temperature. Press and hold either side of the button to rapidly change the temperature setting in one degree increments to either 65° F (18° C) or 85° F (29° C). Then, the set temperature jumps 5° F and stops at either 60° F (16° C), which is maximum cooling, or 90° F (32° C), which is maximum heating. 70