1997 Nissan Maxima Owner's Manual - Page 130

¼ Never jack up the vehicle more than necessary. ¼ Never use blocks on or under the jack. ¼ Do not start or run engine while vehicle is on the jack. ¼ Do not allow passengers to stay in the vehicle while it is on the jack. ¼ Never run the engine with the wheels off the ground. It may cause the vehicle to move. This is especially true for vehicles with limited slip differential carriers. ¼ Incorrect wheel nuts or improperly tightened wheel nuts can cause the wheel to become loose or come off. This could cause an accident. ¼ Do not use oil or grease on the wheel studs or nuts. This could cause the nuts to become loose. As soon as possible tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 72 to 87 ft-lb (98 to 118 N⋅m) Adjust tire pressure to the COLD pressure. COLD pressure: After vehicle has been parked for three hours or more or driven less than 1 mile (1.6 km). COLD tire pressures are shown on the tire placard affixed to the center console lid. Retighten the wheel nuts when the vehicle has been run for 600 miles (1,000 km) after SCE0039 Installing wheel 1. Clean any mud or dirt from the surface between the wheel and hub. 2. Carefully put the wheel on and tighten the wheel nuts finger tight. 3. With the wheel nut wrench, tighten wheel nuts alternately and evenly until they are tight. 4. Lower the vehicle slowly until the tire touches the ground. Then, with the wheel nut wrench, tighten the wheel nuts securely in the sequence as illustrated. 5-5