2004 Nissan Murano Owner's Manual - Page 121
2004 Nissan Murano Manual
Page 121 highlights
light goes off, the keyfob is linked to that memory setting. With the key removed from the ignition switch, press the unlock button on the keyfob. The driver's seat, pedals (Brake and Accelerator) and outside mirrors will move to the memorized position. 2. Turn the ignition ON. 3. Push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, pedals (Brake and Accelerator) and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Confirming memory storage ¼ Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. ¼ If the battery cable is disconnected, or if the fuse blows, the memory will be canceled. In such a case, reset the desired positions using the following procedures. 1. Open and close the driver's door more than two times with the ignition key in the LOCK position. 2. Reset the desired position using the previous procedure. SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ¼ when the vehicle speed is above 4 MPH (7 km/h). ¼ when any two or more of the memory switches are simultaneously pushed while the automatic drive positioner is operating. ¼ when the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. ¼ when the memory switch (1 or 2) is not pushed for at least 1 second. ¼ when the seat has been already moved to the memorized position. ¼ when no seat position is stored in the memory switch. Selecting the memorized position 1. Set the sift selector lever to the P (Park) position. 3-18 Pre-driving checks and adjustments