2004 Nissan Murano Owner's Manual - Page 267
2004 Nissan Murano Manual
Page 267 highlights
¼ After the hitch is removed, seal the bolt holes to prevent exhaust fumes, water or dust from entering the passenger compartment. ¼ Regularly check all hitch mounting bolts are securely mounted. ¼ To reduce the possibility of additional damage if your vehicle is struck from the rear, where practical, remove the hitch and/or receiver when not in use. Safety chain Always use a suitable chains between your vehicle and the trailer. The safety chains should be crossed and should be attached to the hitch, not to the vehicle bumper or axle. Be sure to leave enough slack in the chain to permit turning corners. trailer is hitched. Do not drive the vehicle if it has an abnormal nose-up or nose-down condition; check for improper tongue load, overload, worn suspension or other possible causes of either condition. ¼ Always secure items in the trailer to prevent load shifts while driving. ¼ Be certain your rear view mirrors conform to all federal, state or local regulations. If not, install any mirrors required for towing before driving the vehicle. Trailer lights Trailer lights should comply with federal and/or local regulations. When wiring the vehicle for towing, connect the stop and tail light pickup into the vehicle electrical circuit. Trailer towing tips In order to gain skill and an understanding of the vehicle's behavior, you should practice turning, stopping and backing up in an area which is free from traffic. Steering stability, and braking performance will be somewhat different than under normal driving conditions. ¼ Always secure items in the trailer to prevent load shift while driving. ¼ Avoid abrupt starts, acceleration or stops. ¼ Avoid sharp turns or lane changes. ¼ Always drive your vehicle at a moderate speed. ¼ Always block the wheels on both vehicle and trailer when parking. Parking on a slope is not Tire pressures ¼ When towing a trailer, inflate the vehicle tires to the recommended cold tire pressure indicated on the Tire and Loading Information label (located on the driver's door center pillar). ¼ Trailer tire condition, size, load rating and proper inflation pressure should be in accordance with the trailer and tire manufacturers' specifications. Trailer brakes If your trailer is equipped with a braking system, make sure it conforms to federal and/or local regulations and that it is properly installed. WARNING Never connect a trailer brake system directly to the vehicle brake system. Pre-towing tips ¼ Be certain your vehicle maintains a level position when a loaded and/or unloaded 9-20 Technical and consumer information