2004 Nissan Murano Owner's Manual - Page 126

Make sure the engine is running before using this system. Using the system with the engine off (ignition ON or ACC) for extended periods will drain the battery power, and the engine may not start. Reference symbols: "ENTER" button This is a button on the control panel. "Display" key This is a select key on the screen. By selecting this key you can proceed to the next function. 8. JOYSTICK and "ENTER" push button; refer to page 4-3. 9. "PREV" previous button; refer to page 4-3. 10."DAY/NIGHT" brightness control button; refer to page 4-7. To turn off the screen, push the "DAY/NIGHT" button for more than approximately 1.5 seconds. The screen will change to "CONFIRM DISPLAY OFF YES or NO". HOW TO USE JOYSTICK AND "ENTER" BUTTON Choose an item on the display using the joystick. Push the "ENTER" button only when the use of it is instructed on the display. SAA0796 HOW TO USE "TRIP" BUTTON When the "TRIP" button is pushed, the following modes will display on the screen. TRIP 1 (TIME, DIST, AVG) → TRIP 2 (TIME, DIST, AVG) → OFF You can set the two kinds of journey time (TIME - max 99 hours 59 minutes), trip odometer (DIST - mile or km) and average speed (AVG - MPH or km/h). To reset the TRIP 1 or TRIP 2, push the "TRIP" button or the "TRIP RESET" button for more than approximately 1.5 seconds. NAMES OF THE COMPONENTS 1. "TRIP" drive computer button; refer to page 4-3. 2. "FUEL ECON" button; refer to page 4-4. 3. Clock adjust button; refer to page 4-4. 4. "TRIP RESET" button; refer to page 4-3. 5. "E/M" button; refer to page 4-4. 6. "MAINT" maintenance button; refer to page 4-5. 7. "SETTING" button; refer to page 4-5. HOW TO USE "PREV" BUTTON Finish setup: If you touch "PREV" button after the setup is completed, the setup will start over. Display screen, heater, air conditioner and audio systems 4-3