2004 Nissan Murano Owner's Manual - Page 44

Attaching rear center seat belt Always be sure the rear center seat belt connector tongue and connector buckle are attached. Disconnect only when folding down the rear seat. To connect the buckle: 1. Pull out the connector tongue from the re1 tractor base k . 2. Pull out the seat belt tongue from the retrac2 tor base k . 3. Pull the seat belt and secure the connector 3 buckle until it clicks k . The center seat belt connector tongue and buckle are indicated by the " " and " " mark. The center seat belt connector tongue can be attached only into the rear center seat belt connector buckle. To fasten the seat belt, see "Fastening the seat belt" earlier in this section. ¼ When attaching the rear center seat belt connector, be certain that the seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured. ¼ If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop. SSS0235 Storing rear seat belt buckles Before folding down the seat, put the buckles in the storage of the seat cushion to avoid dropping it under the seat cushion. SEAT BELT EXTENDERS If, because of body size or driving position, it is not possible to properly fit the lap-shoulder belt and fasten it, an extender is available. The extender adds approximately 8 inches (200 mm) of length and may be used for either the driver or front passenger seating position. See your NISSAN dealer for assistance if the extender is required. Seats, restraints and supplemental air bag systems WARNING ¼ Do not unfasten the rear center seat belt connector except when folding down the rear seat. 1-31