2004 Nissan Titan Owner's Manual - Page 132

● Fuel may be under pressure. Turn the cap a third of a turn, and wait for any "hissing" sound to stop to prevent fuel from spraying out and possibly causing personal injury. Then remove the cap. ● Do not attempt to top off the fuel tank after the fuel pump nozzle shuts off automatically. Continued refueling may cause fuel overflow, resulting in fuel spray and possibly a fire. ● Use only an original equipment type fuel filler cap as a replacement. It has a built-in safety valve needed for proper operation of the fuel system and emission control system. An incorrect cap can result in a serious malfunction and possible injury. It could also cause the malfunction indicator lamp to come on. ● Never pour fuel into the throttle body to attempt to start your vehicle. ● Do not fill a portable fuel container on a truck bed liner, rubber truck bed mad, or other insulating material. Static electricity can cause an explosion of flammable liquid, vapor or gas in any vehicle or trailer. To reduce the risk of serious injury or death when filling portable fuel containers: - Always place the container on the ground when filling. - Do not use electronic devices when filling. - Keep the pump nozzle in contact with the container while you are filling it. - Use only approved portable fuel containers for flammable liquid. ● Tighten until the fuel filler cap clicks. Failure to tighten the fuel filler cap malproperly may cause the function indicator lamp (MIL) to illuminate. If the lamp illuminates because the fuel filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. The lamp should turn off after a lamp few driving trips. If the does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. ● For additional information, see the "Malfunction indicator lamp (MIL)" in the "Instruments and Controls" section earlier in this manual. CAUTION ● If fuel is spilled on the vehicle body, flush it away with water to avoid paint damage. 3-12 Pre-driving checks and adjustments