2004 Nissan Titan Owner's Manual - Page 143

2. Reset the desired position using the previous procedure. automatic transmission selector lever is in the P (Park) position. The driver's seat will return to previous position: ● When the key is inserted into the ignition switch. ● When the driver's door is closed with the key turned to LOCK. ● When the key is turned from ACC to ON while the automatic transmission selector lever is in the P (Park) position. The entry/exit function can be adjusted or canceled. For vehicles with navigation system, see "Vehicle electronic systems" in the "Display screen, heater, air conditioner and audio systems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. Selecting the memorized position 1. Set the automatic transmission selector lever to the P (Park) position. 2. Turn the ignition ON. 3. Push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, accelerator and brake pedals, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. ● when the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. ● when the memory switch (1 or 2) is not pushed for at least 1 second. ● when the seat has been already moved to the memorized position. ● when no seat position is stored in the memory switch. The automatic drive positioner system can be adjusted and canceled. For vehicles with navigation system, see "Vehicle electronic systems" in the "Display screen, heater, air conditioner and audio systems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat will automatically move when the automatic transmission selector lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward: ● When the driver's door is opened with the ignition key turned to LOCK. ● When the ignition key is turned from ACC to LOCK with the driver's door open while the SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● when the vehicle speed is above 4 MPH (7 km/h). ● when any two or more of the memory switches are simultaneously pushed while the automatic drive positioner is operating. Pre-driving checks and adjustments 3-23