2004 Nissan Titan Owner's Manual - Page 142
2004 Nissan Titan Manual
Page 142 highlights
3. Adjust the driver's seat, accelerator and brake pedals, and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "Seats" in the "Safety-Seats, seat belts and supplemental air bags" section and "Pedal position adjustment" and "Outside mirrors" earlier in this section. During this step, do not turn the ignition to any position other than ON. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. LPD0260 2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on the keyfob. onds, press the The indicator light will blink. After the indicator light goes off, the keyfob is linked to that memory setting. With the key removed from the ignition switch, press the button on the keyfob. The driver's seat, accelerator and brake pedals, and outside mirrors will move to the memorized position. Confirming memory storage ● Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. ● If the battery cable is disconnected, or if the fuse blows, the memory will be canceled. In such a case, reset the desired positions using the following procedures. 1. Open and close the driver's door more than two times with the ignition key in the LOCK position. MEMORY STORAGE FUNCTION Two positions for the driver's seat, accelerator and brake pedals, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the automatic transmission selector lever to the P (Park) position. 2. Turn the ignition ON. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If memory is stored in the same memory switch, the previous memory will be deleted. Linking a keyfob to a stored memory position A keyfob can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 3-22 Pre-driving checks and adjustments