2003 Subaru Forester Owner's Manual - Page 140
2003 Subaru Forester Manual
Page 140 highlights
Instruments and controls blades. shield wiper blades" section (chapter 11) for replacement instructions. NOTE " The wiper operates only when the ignition switch is in the "ON" or "ACC" position. " Clean your wiper blades and window glass periodically with a washer solution to prevent streaking, and to remove accumulations of road salt or road film. Keep the washer button depressed at least for 1 second so that washer solution will be sprinkled all over the windshield or rear window. " Grease, wax, insects or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove those streaks after operating the washer or if the wiper operation is jerky, clean the outer surface of the windshield or rear window and the wiper blades using a sponge or soft cloth with a neutral detergent or mild-abrasive cleaner. After cleaning, rinse the window glass and wiper blades with clean water. The glass is clean if no beads form on the glass when you rinse with water. " If you cannot eliminate the streaking even after following this procedure, replace the wiper blades with new ones. Refer to the "Replacement of wind- ! Windshield wiper and washer switches ! Windshield wipers 1 2 3 4 1) OFF 2) : Intermittent 3) LO: Low speed 4) HI: High speed HS3031BB To turn the wipers on, push the wiper control lever down. To turn the wipers off, return the lever to the "OFF" po- CONTINUED - 3-23