Apple M8493 Setup Guide - Page 57
Installing Ultra ATA Drives
UPC - 718103028325
View all Apple M8493 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Installing Ultra ATA Drives Your Macintosh can accommodate two internal 1-inch-high ATA devices in the U-shaped drive carrier in drive position 3 in the computer. If your computer has one Ultra ATA drive, it sits in the lower portion of this U-shaped drive carrier. You can install a second ATA device in the upper part of the carrier. 1 Configure your Ultra ATA drive as the secondary drive (sometimes called the "slave drive" or "drive 1"). The drive that came with your Macintosh is designated the primary drive (sometimes called the "master drive" or "drive 0"). Your Macintosh doesn't work with Ultra ATA devices set for cable select mode. 2 Unplug the power cord bundle from the main logic board and the ribbon cable from the drive . Unplug the power cord bundle from the main logic board. Unlock the power cord bundle plug by pressing the small catch located on the side of the plug. (Side view) Unplug the ribbon cable from the hard disk drive. Working Inside Your Computer 57