Asko W6124XW Use and Care Guide English - Page 12

ASKO dryer drum. If the washing machine and dryer are not of matching dimensions or if you have installed a hidden helper between the two appliances, then binding plates are available as optional accessories at the service unit. A B ADJUSTING THE FEET Place the washing machine so that it is stable. It is important that the machine is level to prevent excessive vibrations during spin cycles. Each foot of the washer is adjustable, so you can level the washer on any surface. Once it is level, securely tighten the lock nuts on the feet to prevent excessive vibration during spin cycles. 1. Level the washing machine horizontally and vertically by rotating the adjustable feet (using a No. 32 (1.26") spanner). The feet allow levelling by +/- 1 cm (0.39"). 2. When the appropriate height of feet is set, use the wrench No. 17 (0.67") to firmly fasten the counternuts towards the bottom of the appliance . 3. Tighten the jam nuts (counter nuts) to the end position. This will reduce washing machine noise, vibration, movement etc. to minimum. 1 Built-in installation ASKO washers can be installed beneath a cabinet or worktop with a height of 34" to 35" (863 to 889 2 mm) or in a closet. There must be a gap of about ½" (12 mm) all around the machine, including between the rear edge of the machine's top panel and the back wall. The opening width must be at least 24½" 3 (622 mm). Space must also be available for the fill and drain hoses. See the illustration below for measurements and positions. 622 mm If the drain outlet is higher than 24"(610 mm), the connections will need to be recessed. 12 Customer Care Center, 1-800-898-1879, www.askona.com