Asko W6124XW Use and Care Guide English - Page 44

Cleaning And Maintenance

Page 44 highlights

CLEANING AND MAINTENANCE CLEANING THE FILTER The washing machine has a filter that will retain smaller objects such as coins, buttons, hair etc. 1 Before cleaning, drain the water from the washing machine using the Drain program, and disconnect the washing machine from the power mains. Open the pump filter cover using appropriate tools (emergency door opening tool is located on the back side of the dispenser). 2 Release the water drain hose from the holder. Before cleaning the filter, drain the water from the washing machine by placing the end of the water drain hose over a large shallow container and opening the cap on the water drain hose. 3 Gradually rotate the filter in the counter-clockwise direction and pull it out. 4 Clean the filter thoroughly under running water. 5 Remove all objects and impurities from the filter housing and the impeller. 6 Replace the filter as shown in the figure and fasten it by rotating in the clockwise direction. For a good seal, the filter seal surface should be clean. Also re-install the drain hose. 44 Customer Care Center, 1-800-898-1879, www.askona.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

44
Customer Care Center, 1-800-898-1879, www.askona.com
CLEANING AND MAINTENANCE
CLEANING THE FILTER
The washing machine has a
lter that will retain smaller objects such as coins, buttons, hair etc.
1
Before cleaning, drain the water from the washing
machine using the Drain program, and disconnect
the washing machine from the power mains.
Open the pump
lter cover using appropriate tools
(emergency door opening tool is located on the back
side of the dispenser).
2
Release the water drain hose from the holder.
Before cleaning the
lter, drain the water from the
washing machine by placing the end of the water drain
hose over a large shallow container and opening the
cap on the water drain hose.
3
Gradually rotate the
lter in the counter-clockwise
direction and pull it out.
4
Clean the
lter thoroughly under running water.
5
Remove all objects and impurities from the
lter
housing and the impeller.
6
Replace the
lter as shown in the
gure and
fasten it by rotating in the clockwise direction. For
a good seal, the
lter seal surface should be clean.
Also re-install the drain hose.