Asus P5BV-C User Guide - Page 79
Configure DRAM Timing by SPD [Enabled], PEG Port Configuration
UPC - 610839157372
View all Asus P5BV-C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
DRAM Frequency [Auto] When Configure DRAM Timing by SPD is enabled, you are not allowed to change the setting of this item. The motherboard automatically sets the DDR operating frequency according to the DRAM SPD. When Configure DRAM Timing by SPD is disabled, this item allows you to set the DDR operating frequency manually. Configuration options: [Auto] [667 MHz] [800 MHz] Configure DRAM Timing by SPD [Enabled] When this item is enabled, the DRAM timing parameters are set according to the DRAM Serial Presence Detect (SPD). When disabled, you can manually set the DRAM timing parameters through the DRAM sub-items. The following sub-items appear when this item is disabled. Configuration options: [Disabled] [Enabled] DRAM CAS# Latency [5] Controls the latency between the SDRAM read command and the time the data actually becomes available. Configuration options: [3] [4] [5] [6] DRAM RAS# to CAS# Delay [6 DRAM Clocks] Controls the latency between the DDR SDRAM active command and the read/write command. Configuration options: [3 DRAM Clocks] [4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks] DRAM RAS# Precharge [6 DRAM Clocks] Controls the idle clocks after issuing a precharge command to the DDR SDRAM. Configuration options: [3 DRAM Clocks] [4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks] DRAM RAS# Activate to Precharge Delay [15 DRAM Clocks] Configuration options: [9 DRAM Clocks] [10 DRAM Clocks] ~ [15 DRAM Clocks] Initiate Graphic Adapter [PEG/PCI] Allows selection of the graphics controller to use as primary boot device. Configuration options: [PCI/PEG] [PEG/PCI] PEG Port Configuration PEG Port [Auto] Allows you to set or disable the PCI Express Graphic port. Configuration options: [Auto] [Disabled] ASUS P5BV-C Series 4-21