Behringer PMP1000 Manual - Page 13
Installation - europower
View all Behringer PMP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
13 EUROPOWER PMP6000/PMP4000/PMP1000 User Manual 4. Installation 4.1 Mains connection The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all of the international safety certification requirements. Blown fuses must be replaced by fuses of the same type and rating. ◊ Please make sure that all units have a proper ground connection. For your own safety, never remove or disable the ground conductor from the unit or of the AC power cord. 4.2 Audio connections The inputs and outputs of your BEHRINGER EUROPOWER are unbalanced 1/4" mono jacks-except for the mono channel line inputs, which are balanced 1/4" stereo jacks. Of course, all inputs and outputs work with both balanced and unbalanced connectors. The tape in and outputs are on RCA connectors. ◊ Please ensure that only qualified personnel install and operate the PMP. During installation and operation, the user must have sufficient electrical contact to earth. Electrostatic charges might affect the operation of the unit. Unbalanced ¼" TS connector strain relief clamp sleeve tip Balanced use with XLR connectors 21 3 input 1 = ground/shield 2 = hot (+ve) 3 = cold (-ve) 12 3 output For unbalanced use, pin 1 and pin 3 have to be bridged Fig. 4.3: XLR connectors ¼" TRS footswitch connector strain relief clamp sleeve ring tip sleeve ground/shield ring FX2 sleeve (ground/shield) tip FX1 tip (signal) Fig. 4.1: ¼" TS connector Balanced ¼" TRS connector strain relief clamp sleeve ring tip Fig. 4.4: ¼" mono plug for footswitch Power amp insert send return ¼" TRS connector strain relief clamp sleeve ring tip sleeve ground/shield sleeve ground/shield ring cold (-ve) tip hot (+ve) For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug. ring send (out) tip return (in) Connect the insert send with the input and the insert with the output of the output e ects device. Fig. 4.5: Stereo ¼" TRS connector for power amp ISR connection Fig. 4.2: ¼" TRS connector