Belkin F5D6230-3 User Manual - Page 66

and service name. Make sure

Get Belkin F5D6230-3 PDF manuals and user guides View all Belkin F5D6230-3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 66 highlights

Troubleshooting My connection type is Dynamic IP Address. I cannot connect to the Internet. My connection type is PPPoE. I cannot connect to the Internet. 2. Make sure the cable or DSL line is properly attached on your cable or DSL modem. Refer the manual of your modem to verify that it works normally. 3. Make sure the network cable between the modem and the router is well connected. Power off the modem; wait a few seconds and then power it on again. 4. Your ISP may bind your connection to the MAC address of your computer's NIC. Clone your MAC address. 1. Since your connection type is PPPoE, your ISP will assign you an account name and password and service name. Make sure the Router connection type is configured as PPPoE and fill these settings are entered properly. 2. Make sure your computers are correctly configured and all network cables are properly connected. 3. Make sure the coaxial cable or DSL line is properly attached on your cable or DSL modem. Refer the manual of your modem to verify it works normally. 65

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
65
Troubleshooting
My connection type is Dynamic
IP Address. I cannot connect to the
Internet.
My connection type is PPPoE. I
cannot connect to the Internet.
2. Make sure the cable or DSL line
is properly attached on your
cable or DSL modem. Refer the
manual of your modem to verify
that it works normally.
3. Make sure the network cable
between the modem and the
router is well connected. Power
off the modem; wait a
few seconds and then power it
on again.
4. Your ISP may bind your
connection to the MAC address
of your computer’s NIC. Clone
your MAC address.
1. Since your connection type is
PPPoE, your ISP will assign you
an account name and password
and service name. Make sure the
Router connection type is
configured as PPPoE and fill these
settings are entered properly.
2. Make sure your computers are
correctly configured and all
network cables are properly
connected.
3. Make sure the coaxial cable or
DSL line is properly attached on
your cable or DSL modem. Refer
the manual of your modem to
verify it works normally.