Bosch 11241EVS Use and Care Manual - Page 14

Adding Detergent and Rinse Agent (continued) Opening the Detergent Dispenser Cover NOTE: To open the detergent dispenser cover, press the blue release in the direction shown in Figure 22. Pressing down on the release tab will not open the cover. Press the blue release tab in the direction shown by the arrow in Figure 22. Figure 22 The cover will slide open to the right. Filling the Rinse Agent Dispenser Open the rinse agent dispenser by pressing the star on the cover with your index finger while lifting the tab with your thumb as shown in Figure 23. Figure 23 Return the rinse agent dispenser cover to its shut position and press it firmly so that the cover snaps shut. NOTE: Figure 24B represents a completely empty rinse agent reservoir. Refill the rinse agent dispenser when the rinse agent reservoir level indicator as shown in Figure 24B begins to show a silver background with black lines or when the Refill Rinse Agent indicator comes on. NOTE: After filling the rinse agent dispenser, the Refill Rinse Agent Indicator will go out in a few minutes after the dishwasher door is shut. Rinse Agent Dispenser Regulator The amount of rinse agent dispensed can be regulated to control spotting and streaking. The Rinse Agent Dispenser Regulator as shown in Figure 25 leaves our factory set at 4. Figure 25 Add liquid rinse agent to the dispenser as shown in Figure 24A until the rinse agent reservoir is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full. Figure 24 B To adjust the amount of rinse agent dispensed: 1. Open the rinse agent dispenser cover. 2. If your dishes are streaked after washing, turn the regulator to a lower number. 3. If your dishes are spotted after washing, turn the regulator to a higher number. 12