Bosch SHP78CM2N Installation Instructions - Page 8
Visual Leak Check, Pre-level the Dishwasher
View all Bosch SHP78CM2N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
en-us Installation Procedure 1. Attach elbow joint to the water inlet valve with the open end facing towards the direction of the sink, either to the left or the right. . Turn by hand and do not over tighten . 2. Attach hot water line to elbow. 4.2 Visual Leak Check 1. Temporarily hook up water supply under the sink by going through the front of the sink cabinet. Do not turn on the power or push the dishwasher into the niche. 2. Turn the water on and check for leaks at the water inlet hose connection on the back of the dishwasher. 4.3 Pre-level the Dishwasher Set the dishwasher to the correct height before it goes into the cabinet. 1. Measure the height of the cabinet opening. 2. Raise the front of the dishwasher to approximately 1/2" lower than the height of the opening by turning the feet clockwise. ‒ You can raise the rear foot after the unit is in the cabinet opening. 3. Use two wrenches to tighten, using one to stabilize and avoid putting stress on the water inlet valve. The maximum height the unit can be raised to is 34.5" (867.3 mm) 8