Brother International BAS-326F-0 Instruction Manual - English - Page 62
New BAS-311F-L X -110 mm
View all Brother International BAS-326F-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
10.DIPSWITCH DIP switch A SW No. When ON A-5 After sewing is completed, work clamp does not automatically rise (only in split mode) A-6 Clamping force output is produced (Inner clamping device available as an option) A-7 Single-pedal operation using the starting switch; when the starting switch is pressed, the work clamp drops, and when it is released, sewing starts. A-8 Thread breakage detector device is activated (available as an option) DIP switch B SW No. When ON B-1 Single split mode activated B-2 BAS-311F-L: The sewing area in the X direction is extended to 230 mm from 220 mm.* B-3 Thread is not trimmed after an emergency stop. B-4 Needle cooler output is produced. B-5 When a rotating-type thread breakage detector device is used, detection precision is increased from 8 to 14. When a fiber-type thread breakage detector device is used, detection precision is increased from 5 to 10. B-6 Fiber-type thread breakage detector device is ON, and DIP switch A - 8 is ON (available as an option) When using a 3-stage pedal B-7 If DIP switch A -2 is ON at the same time, the presser foot will drop at the same time that both work clamps drop. B-8 Feeding speed is switched to high speed. * If using the work clamp and sewing data for the older BAS-311EL model, set DIP switch B -2 ON. The BAS-311 L-type has a different length for the sewing area in the X direction (X=220 mm). Old BAS-311EL X -100 mm +120 mm New BAS-311F-L X -110 mm +110 mm Note The break of the sewing pattern is apt to occur in the extended sewing area. BAS-311F-0, 311F-L, 326F-0 55