Brother International BAS-326F-0 Instruction Manual - English - Page 64
to the vicinity of the needle up stop position, When the upper shaft is stopped
View all Brother International BAS-326F-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
10.DIPSWITCH DIP switch D SW No. When ON D-1 The first two stitches at the sewing start will be sewn at low speed (approx. 260 rpm) D-2 The last two stitches at the sewing end will be sewn at low speed (approx. 260 rpm) D-3 - D-4 The last two stitches at the sewing end will be sewn at low speed (approx. 700 rpm) D-5 - D-6 Slow-speed sewing at the sewing start will be canceled D-7 When the upper shaft is stopped, the motor will change direction and the needle bar will return to the vicinity of the needle up stop position* D-8 During an emergency stop, the thread is trimmed and the needle bar stops in the raised position. * When the motor operates in reverse to raise the needle, the thread take-up will stop at a position which is lower than its normal stopping position. As a result, the thread take-up will rise slightly at the sewing start, and this may result in the thread pulling out under certain conditions. BAS-311F-0, 311F-L, 326F-0 57