Brother International CP-2000 Owners Manual - English - Page 17
Re-attaching the stand, Use the six screws three on each side to attach the stand to the back
View all Brother International CP-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
2. Setup 5 While holding both sides of the copyboard, hook the brackets at the back of the copyboard onto the wall-mounting bar pegs. a Do not release the copyboard until you are sure that it is securely mounted on the wallmounting bar. Do not push the unit upward or to either side, otherwise it may fall down. 6 Attach the tray by sliding its slots over the two brackets on the front of the copyboard above the printer. bc Do not subject the tray to strong impacts or use it in any way other than for holding markers and erasers. Re-attaching the stand 1 Lay the copyboard on the floor facing downward with the printer control panel and writing surface positioned over a piece of cloth or other protective sheet to prevent them from being damaged. 2 Use the six screws (three on each side) to attach the stand to the back of the copyboard by tightening the screws in order according to the numbering on each bracket of the stand (1, 2, then 3). + While the stand is being used, it is recommended that the wall-mounting brackets be removed in order to avoid that they be pulled on with excessive force. After removing the wall-mounting brackets, re-attach the plates. Refer to step 4 of Mounting the copyboard on page 11. 15