Brother International CP60X Operation Manual - Page 19
Buttonhole sewing
View all Brother International CP60X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
6 Attach blind stitch foot "R". 7 Select a stitch. * Stitches may differ depending on the model. Check stitch selections on the machine's body, and then select the stitch number. 8 Remove the flat bed attachment to use the free arm. 9 Slide the item that you wish to sew onto the free arm, make sure that the fabric feeds correctly, and then start sewing. 10 Position the fabric with the edge of the folded hem against the presser foot guide, and then lower the presser foot lever. 13 Stop sewing when you are finished, and raise the presser foot and needle to pull the fabric under the presser foot towards the back of the machine. Note • Be sure to pull the fabric towards the back of the machine after sewing. If you pull the fabric toward side or forward, the presser foot may be damaged. 14 Remove the basting stitching and turn the fabric with the right side facing out. Wrong side of fabric Right side of fabric Buttonhole sewing The maximum buttonhole length is about 28 mm (1-1/8 inches) (diameter + thickness of the button). Buttonholes are sewn from the front of the presser foot to the back, as shown below. Wrong side of fabric Presser foot guide Fold of hem 11 Adjust the stitch width until the needle slightly catches the fold of the hem. (page 15) Needle drop point When you change the needle drop point, raise the needle, and then change the stitch width. * To make fine adjustments to the needle drop point, adjust the stitch width setting. Memo • Blind hem stitches cannot be sewn if the left needle drop point does not catch the fold. If the needle catches too much of the fold, the fabric cannot be unfolded and the seam appearing on the right side of the fabric will be very large, leaving an unattractive finish. 12 Sew with the fold of the hem against the presser foot guide. 1 Reinforcement stitching * Stitches may differ depending on the model. Check the stitches lineup on your machine's body, and then select the stitch number. The part names of buttonhole foot "A", which is used to create buttonholes, are indicated below. 1 Button guide plate 2 Presser foot scale 3 Presser foot pin 4 Marks on buttonhole foot 5 5 mm (3/16 inch) A e a b cd Note • Before sewing buttonholes, check the stitch length and width by sewing a trial buttonhole on a scrap piece of fabric used for your project. 19